Hypertherm PAC500 Product Configuration - Manual (Page 10)

1-5 PAC-500
ORDERING INFORMATION
Numerous configurations are possible for the PAC-500 system. The figure below represents
a 1-Torch 1000-amp system with THC-1/DCC, inductive IHS, argon-hydrogen manifold, and
water muffler (Note: The water muffler cannot be operated above 700 amps). Use this figure
as a guide when configuring a PAC-500 system. The system below is also represented in
block diagram form on page 1-31. Other block diagrams for PAC-500 systems begin on page
1-28.
Each numbered step is cross-referenced in four areas: in the sample gantry system diagram
below; in block diagrams to clarify interfacing components; in the accompanying parts list;
and in the specifications section to clarify size and weight of major components. (Block
diagrams are offered to clarify connection points and do not necessarily reflect relative sizes
or distances between components.)
Note: If the cutting system has a power track for cabling and hosing, be certain to see the
Specifications section to check hose, cable and connector diameters.
Figure 1.3 1000-Amp PAC-500 System in a Gantry Layout
1
1
2
3a
3e
3f
3c
3d
4
6
7a
8a
9b
11c
11c
11c
13
14
14
4
11c
14
15
Power
Water
Power/Gas
Water softener
(if required)
10