Hypertherm SensorOHC - Manual (Page 9)

Section 1: Overview 5
Hardware Specifications
Main Power Supply:
24 Vdc +/- 10%, 50/60 Hz
Compatible Lifter Motors:
DC shunt motor 24Vdc, 2 Amps to 6 Amps
Operating Temperature:
0 to +50 deg C
Control Range:
Linear 0.1 inch to 1.0 inch (2.5 to 25 mm)
(standard sensor & cable)
Height Measuring Technology:
Capacitive Ring with Coax Cable
Accuracy:
0.01 inch (0.25 mm) w/ representative Lifter
(dependent on lifter mechanics)
HF Coax Cable:
500 mm to 1500 mm (1000 mm standard)
Standard Sensor:
Stainless Steel Ring 100 mm outer & 50 mm inner
diameters. Can be calibrated for others
Dimensions:
8.50” (216mm) W x 4.21” (107mm) D x 4.02” (102mm) H
Control Type:
Digital Micro Processor based
Motor Output:
Full “H” Bridge PWM with current sensing
Control Interface:
Optically Isolated I/O on “D” connectors
Outputs: Digital
In-Position Output
Digital Error Output
Digital Plate Contact Output
Inputs:
Digital Manual/Auto Select
Digital Manual Up
Digital Manual Down
Digital Upper Limit Switch
Digital Lower Limit Switch
Digital Second Height Select
Remote Height Set-point Pot
Second Height Set-point Pot
Front
Panel Indicators green Power
yellow Upper Limit Switch
green In Position
yellow Lower Limit Switch
red Attention/Error Code