Hyundai 2011 Tucson - Manual (Page 195)

Features of your vehicle
114 4
Note:
Once pairing with the phone is com-
pleted, there is no need to pair with
that phone again unless the phone is
deleted manually from the audio sys-
tem (refer “Deleting Phone” section)
or the vehicle’s information is
removed from the phone.
By Voice Recognition
➀
Press button.
➁
Say “Set Up”.
- The system replies with available
commands.
- To skip the information message, press
again and then a beep is heard.
➂
Say “Pair Phone”.
➃
Say “Yes” to proceed.
➄
Say the name of your phone when
prompted.
- Use any name to uniquely describe
your phone.
➅
Bluetooth ® system will repeat the
name you stated.
➆
Say "Yes" to confirm.
➇
The audio displays “searching ----
passkey: 0000” and asks you to initiate
pairing procedure from the phone.
➈
Search the Bluetooth ® system on your
phone .Your phone should display
your [vehicle model name] on the
Bluetooth ® device list. Then attempt
pairing on your phone
➉
After Pairing is completed, your phone
will start to transfer phone/contact list
to the audio system.
- This process may take from a few min-
utes to over 10 minutes depending on
the phone model and number of
entries in the phone/contact list.
✽ ✽ Tip
Press button. Pair the device after searching for
Bluetooth
® devices in your mobile phone.
Once pairing is complete, you will hear
the following message.
“My Phone” say
“Yes” to proceed, otherwise say “Back” or
“Cancel”
“Ready for pairing...please use your
phone to connect to the system the
pairing pass key is 0000”
“Yes”
“Pairing Complete”
“Connection Complete”
Beep~ ♪
“ Please say a name for the phone ”
“Setup” say
“Pair phone”, “Select phone”, “Delete
phone”, “Change priority” or “Bluetooth off”
“Pair Phone” say
“ Yes ” to proceed, otherwise say “ Back ” or
“ Cancel ”
“Setup”
“Pair Phone”
“Yes”
Ex: “My phone” or “John”