Hyundai 2008 Elantra - Manual (Page 192)

4 119
Features of your vehicle
1. XM Selector
• This is XM selector and it will turn to
each mode in the following order each
time you press the button.
- XM1 XM2 XM3
• When you press this button when you
are listening to CD or RADIO, the sys-
tem will automatically turn to XM
mode.
• When ignition switch of the automobile
is set to ACC (1st notch) or ON (2nd
notch) and when you press this button,
XM will be on even when the audio
system was turned off.
2. LCD (Liquid Crystal Display)
It displays the XM1, XM2, XM3, Preset
Number, Title of the Channel Received,
EQ Mode (CLASSIC, POP, ROCK,
JAZZ), and SCAN Status when listening
to XM.
3. SCAN Button
When you press this button, the player
will play 10 seconds of each channel
(LCD will display "SCAN"). Press it again
to cancel scanning. Also, press and this
button for more than 0.8 seconds to play
the channels memorized to the preset
buttons for 10 seconds each. (LCD will
display "corresponding channel number",
"<P>", and "SCAN".) Press it again to
cancel scanning.
4. Information Button
You can see the information of the chan-
nel currently received and you can switch
to different information by pressing this
button in the following order.
- Title
Name Category Current
State
5. Channel Move (Seek Up/Down)
Button
• When you press this button, the chan-
nel will move automatically and stop at
the next available channel and play the
channel. The display will cycle once
through the Channel, Title, Name and
Category for selected channel.
(Press [
] to move to the higher fre-
quencies, press [ ] to the lower fre-
quencies automatically.)
Press and hold either the down or up at
a fast rate. The display will show the
Channel Name and Number while tun-
ing at the fast rate.
• Radio ID :Seek or tune to XM channel
0 to display the Radio ID.
6. Preset Memory Button
Press this button and hold for less than
0.8 seconds to listen to the channel
memorized to the button. Also, when you
are listening to the channel other than
the channel memorized to the button
using TUNE or SEEK, press the button
you wish to memorize current channel to
and hold for more than 0.8 seconds until
it beeps to memorize the channel.