IBASE MB941 - Manual (Page 31)

BIOS SETUP
MB941 User’s Manual 27
BIOS SETUP UTILITY
Main Advanced PCIPnP Boot Security Chipset Exit
IDE Configuration
Options:
Disabled
Compatible
Enhanced
<- Select Screen
↑↓ Select Item
+- Change Field
Tab
Select Field
F1 General Help
F10 Save and Exit
ESC Exit
ATA/IDE Configuration [Compatible]
Legacy IDE Channels [SATA Pri, PATA Sec]
► Primary IDE Master : [Not Detected]
► Primary Slave Master : [Not Detected]
► Secondary IDE Master : [Hitachi HDS72]
► Secondary IDE Slave : [Not Detected]
IDE Detect Time Out (Sec) [35]
The IDE Configuration menu is used to change and/or set the
configuration of the IDE devices installed in the system.
BIOS SETUP UTILITY
Main Advanced PCIPnP Boot Security Chipset Exit
Configure Win627UHG Super IO Chipset
<- Select Screen
↑↓ Select Item
+- Change Field
Tab
Select Field
F1 General Help
F10 Save and Exit
ESC Exit
Serial Port1 Address [3F8/IRQ4]
Serial Port2 Address
Serial Port2 Mode
Serial Port3 Address
Serial Port3 IRQ Select
Serial Port4 Address
Serial Port4 IRQ Select
Parallel Port Address
Parallel Port Mode
Parallel Port IRQ
[2F8/IRQ3]
[Normal]
[3E8]
[IRQ11]
[2E8]
[IRQ10]
[378]
[Normal]
[IRQ7]
Restore on AC Power Loss [Power Off]
Onboard Serial Port/Parallel Port
These fields allow you to select the onboard serial ports and their
addresses. The default values for these ports are:
Serial Port 1 3F8/IRQ4
Serial Port 2 2F8/IRQ3
Serial Port 3 3E0/IRQ10
Serial Port 4 Disabled
Parallel Port 378/IRQ7