IBASE IB827 - Manual (Page 40)

BIOS SETUP
36 IB827 User’s Manual
Phoenix - AwardBIOS CMOS Setup Utility
SuperIO Device
POWER ON Function BUTTON ONLY ITEM HELP
KB Power ON Password Enter Menu Level >
Hot Key power ON Ctrl-F1
Onboard FDC Controller Enabled
Onboard Serial Port 1 3F8/IRQ4
Onboard Serial Port 2 2F8/IRQ3
UART Mode Select Normal
RxD , TxD Active Hi, Lo
IR Transmission Delay Enabled
UR2 Duplex Mode
Use IR Pins
Onboard Parallel Port Half
IR-Rx2Tx2
378/IRQ7
Parallel Port Mode
EPP Mode Select
ECP Mode Use DMA
PWRON After PWR-Fail SPP
EPP1.7
3
Off
Phoenix - AwardBIOS CMOS Setup Utility
2nd Super IO Device
Onboard Serial Port 3 2A0h ITEM HELP
Serial Port 3 Use IRQ IRQ11 Menu Level >
Onboard Serial Port 4 2A8h
Serial Port 4 Use IRQ IRQ10
IDE HDD Block Mode
This field allows your hard disk controller to use the fast block mode to
transfer data to and from your hard disk drive.
IDE DMA Transfer Access
By default, this field is enabled.
OnChip Primary/Secondary PCI IDE
The integrated peripheral controller contains an IDE interface with
support for two IDE channels. Select Enabled to activate each channel
separately.
IDE Primary/Secondary Master/Slave PIO
These fields allow your system hard disk controller to work faster.
Rather than have the BIOS issue a series of commands that transfer to or
from the disk drive, PIO (Programmed Input/Output) allows the BIOS to
communicate with the controller and CPU directly.
The system supports five modes, numbered from 0 (default) to 4, which
primarily differ in timing. When Auto is selected, the BIOS will select
the best available mode.