IHSE USA 474 Series Draco major - Manual (Page 132)

Draco major
132 2011-10-11
6.3 Crosspoint Mode
In Crosspoint Mode, assignments of inputs to outputs can be made. As
the video signals of a CPU port can be connected to several CON ports,
the KM signal can only be connected to a CON port that includes the
corresponding video signal at the same time.
All existing connections can be overwritten in the CP Mode. That is why
only users with power user rights have access to this mode.
The switching result has to be controlled by the user, because there is no
plausibility check for reasons of highest flexibility.
6.3.1 Crosspoint Switch Function (CON Ports)
In the menu Crosspoint Switch the various consoles that are switchable
to available CPUs are shown. For an optimal overview, a matrix display is
used in this case.
You can only assign 1x video (MON) and 1x keyboard and mouse control
(K/M) to any console. If another CPU is selected (K/M or MON), an
existing connection will be eventually stopped.
You can assign 1x MON without K/M to any console. If you assign 1x K/M
to a console, you will also have to assign the corresponding video signal
to this console.
The switching operation of a single keyboard/mouse or video signal is
done by pressing the key <Space>. The combined switching of K/M and
MON
is done by the key <Enter>. The switching is done immediately. If
the switching is done on an existing connection, the connection will be
stopped.
The switching function is done immediately. The user has to take care of
the legitimacy of the switching operation. There is no control by the
system.
You have the following possibilities to access the menu: