innovaphone IP38 - Manual

Quick Installation Guide: How to get started?
Installation guide for innovaphone gateway IP38
Set-up
When installing the device, please ensure it has sufficient ventilation, especially
when the device is installed in a closed cabinet. A special frame for 19” racks is
available for mounting two devices in one height unit. (product number 01-00999-
001).
The device is only designed for use in dry rooms. Operating temperature is
between 0 °C and 45 °C with relative humidity of 10 % to 90 % (non-
condensing). Hardware problems can occur if the device is used in environments
outside of this range. Please wait until the device has adapted to the new
environment before carefully putting the device into operation.
Reduce the risk of accidents by laying the connecting cables carefully. Take care
not to bend, pull or put too much mechanical strain on all connecting cables.
Power supply
The power supply can be a innovaphone power supply (PSU, article number
03-00010-226) or Power over Ethernet (PoE) according to IEEE 802.3af. When
used with DC Input use only the designated innovaphone power supply. Other
power supplies and power cables could damage the device. Connect the
innovaphone power supply (PSU) to the DC Input labeled with DC .
The device is switched on as soon as it is connected to the power
supply and the LED labelled Ready is illuminated. The device cannot be operated
if the network fails. However, the device maintains its settings.
Configuration
Use an Ethernet cable to connect the device to your network. Device
configuration takes place over a web browser using the device’s
IP address.
There are various different ways of putting a device into operation and assigning
an IP address to it. Initially, the device will try to establish a connection to
the DHCP server. If this is possible and the device is in the same subnet, the
NetBIOS method can be used. The NetBIOS name is made up of the device
model and part of the MAC address as follows: IPXXX-YY-YY-YY, whereby
the symbol X should be replaced with the device model name and the symbol
Y with the last three Byte of the gateway's MAC address(e.g. IP6010-06-15-
B2 or IP28-05-14-B1). The MAC address can be found on the sticker at the
back of the device.
If your device is in a different subnet, access can take
place over the IP address. You can determine which IP address has been
assigned with the help of the MAC address from the DHCP lease.
If it is not possible to set up a connection to a DHCP server, it is necessary to
short press the Reset button. This assigns a static IP address to both Ethernet
ports – either 192.168.0.1 (ETH0) or 192.168.1.1 (ETH1). Attention: the
computer has to be in the same subnet.
innovaphone® AG, Böblinger Straße 76, 71065 Sindelfingen, Germany, Tel +49 7031 7 30 09-0, Fax +49 70 31 7 30 09-99
[email protected], www.innovaphone.com, Version: March 2014, Copyright © 2014 innovaphone® AG
Errors and omissions excepted. All information, technical specifications and delivery times may be subject to change.