Jetway Computer NF9Q - Manual (Page 43)

38
 Graphics Configuration
Press [Enter] to make further settings for Graphics Configuration.
Graphics Configuration
Primary IGFX Boot Display
Use this item to select the video device which will be activated during POST. This
has no effect if external graphics present. 'Secondary boot display selection will
appear based on your selection. VGA modes will be supported only on primary
display.
The optional settings are: [VBIOS Default]; [CRT]; [HDMI]; [DVI]; [LVDS].
*When set as [CRT]; [HDMI]; [DVI] or [LVDS], the following sub-item shall
appear:
Secondary IGFX Boot Display
The optional settings are: [Disabled]; [HDMI]; [DVI]; [LVDS].
Primary Display
Use this item to select which of IGFX/PEG/PCI graphics device should be primary
display or select SG for switchable GFX.
The optional settings are: [Auto]; [IGFX]; [PCIE].
Internal Graphics
The optional settings are: [Auto]; [Disabled]; [Enabled].
Aperture Size
The optional settings are: [128MB]; [256MB]; [512MB].
DVMT Pre-Allocated
Use this item to select DVMT 5.0 pre-allocated (fixed) graphics memory size used
by the internal graphics device.
The optional settings are: [32M]; [64M]; [128M]; [256M]; [512M]; [1024M].
DVMT Total Gfx Mem
Use this item to select DVMT 5.0 total graphics memory size used by the internal
graphics device.
The optional settings are: [128M]; [256M]; [MAX].
LCD Control
Active LFP
The optional settings are: [Disabled]; [Enabled].
[Disable]: VBIOS does not enable LVDS.