Denon RCD-CX1 - Manual (Page 27)

Get
ting Star
ted
Connections
Set
up
Pla
ybac
k
Set
ting the
Timer
Other F
unctions
Tr
oubleshooting
ENGLISH

Tr
oubleshooting
Symptom Cause Countermeasure Page
Buzzing noise in
FM broadcasts. • The antenna cable is not properly
connected.
• Noise interference from a nearby
electronic device equipped with
a microprocessor, or the radio
broadcast signal is weak.
• Connect the antenna properly.
• Reposition the equipment or the
positions or directions of the
connection cables, antenna, etc.
• Connect an outdoor antenna.
10
–
–
Hissing or buzzing
noise is heard in
AM broadcasts. • Noise interference from a
nearby monitor, etc., or there
is interference in the broadcast
signal.
• Turn off the monitor.
• Change the position or direction
of the AM loop antenna.
• Connect an outdoor antenna.
–
–
–
Humming noise
is heard in AM
broadcasts. • There is interference from current
in power cords.
• Connect an outdoor antenna. –
G TunerH
Symptom Cause Countermeasure Page
When playing
records, a wailing
noise (howling) is
produced when
the volume is
raised. • The player and speakers are too
close together.
• The floor is soft and vibrates
easily.
• Move the player and speakers as
far apart as possible.
• Use cushions or spikes to absorb
the vibrations of the speakers
being conveyed from the floor.
–
–
G Record PlayerH
Symptom Cause Countermeasure Page
iPod cannot be
played. • Device you want to play and set
input source do not match.
• Cable is not properly connected.
• Control dock for iPod’s AC
adapter is not connected to
power outlet.
• Select an appropriate input
source.
• Reconnect.
• Plug the control dock for iPod’s
AC adapter into a power outlet.
18
9
–
G iPodH
Symptom Cause Countermeasure Page
Set does not work
properly when
remote control
unit operated. • Batteries are worn.
• You are operating outside of the
specified range.
• Obstacle between main unit and
remote control unit.
• The batteries are not inserted in
the proper direction, as indicated
by the polarity marks in the
battery compartment.
• The set’s remote control sensor
is exposed to strong light (direct
sunlight, inverter type fluorescent
bulb light, etc.).
• Replace with new batteries.
• Operate within the specified
range.
• Remove the obstacle.
• Insert the batteries in the
proper direction, following the
polarity marks in the battery
compartment.
• Move the set to a place in which
the remote control sensor will
not be exposed to strong light.
4
4
4
4
4
G Remote Control UnitH
Specifications
n Receiver section
Rated output: 2-channel driving
37.5 W + 37.5 W (8 Ω/ohms, DIN, 1 kHz, T.H.D. 0.7 %)
75 W + 75 W (4 Ω/ohms, DIN, 1 kHz, T.H.D. 0.7 %)
High frequency distortion: 0.05 % (Rated output: –3 dB), 8 Ω/ohms, 1 kHz
Output terminals: Speaker 4 ~ 16 Ω/ohms
Suited for headphones/stereo headphones
Equalizer amplifier output
(REC OUT terminals):
Rated output : 150 mV
Input sensitivity / Input impedance: PHONO (MM) : 2.5 mV / 47 kΩ/kohms
PHONO (MC) : 0.2 mV / 100 Ω/ohms
CD, LINE1, LINE2 : 130 mV / 47 kΩ/kohms
RIAA deviation: PHONO (MM) : 20 Hz ~ 20 kHz ±0.5 dB
PHONO (MC) : 30 Hz ~ 20 kHz ±0.5 dB
Reception frequency range: FM : 87.5 MHz ~ 107.9 MHz AM : 520 kHz ~ 1710 kHz
Reception sensitivity: FM : 1.5 μV / 75 Ω/ohms AM : 20 μV
FM channel separation: 35 dB (1 kHz)
FM S/N ratio: Monaural : 74 dB Stereo : 70 dB
FM harmonic distortion: Monaural : 0.3 % Stereo : 0.4 %
S/N ratio: PHONO (MM) : 84 dB
(With input terminals short-circuited, 5 mV input signal)
PHONO (MC) : 70 dB
(With input terminals short-circuited, 0.5 mV input signal)
(A-weighted network): LINE1, LINE2 : 95 dB (input terminals short-circuited)
Tone control: BASS : 100 Hz ± 8 dB
TREBLE : 10 kHz ± 8 dB
Frequency response: 10 Hz ~ 40 kHz (+0.5 dB, –3 dB) (INPUT: LINE1, PURE DIRECT: ON)
n Clock/Timer section
Clock type: Power line frequency synchronized method (Within ±60 seconds per month)
Timer: Everyday timer / Once timer : One system each
Sleep timer : Max. 90 minutes
n CD section
[Super Audio CD] [CD]
• Analog output
Signal type:
1-bit DSD 16-bit linear PCM
Sampling frequency: 2.822 MHz 44.1 kHz
Usable discs: Super Audio CD Compact Disc
• Digital output
Optical:
– –15 ~ –21 dBm
Emission wavelength: – 660 nm
n General
Power supply: AC 120 V, 60 Hz
Power consumption: 50 W
0.3 W (Standby)
Maximum external dimensions: 300 (W) x 110 (H) x 341 (D) mm
Weight: 8.0 kg
n Remote control unit (RC-1109)
Remote control method: Infrared pulse method
Batteries: R03/AAA Type (two batteries)
Maximum external dimensions: 44 (W) x 233 (H) x 22 (D) mm
Weight: 165 g (including batteries)
z For purposes of improvement, specifications and design are subject to change without notice.
Specifications
1.RCD-CX1E3_ENG.indd 24 2008/06/30 11:12:56