Denon RCD-CX1 - Manual (Page 5)

ENGLISH

Check that the following parts are supplied with the product.
q Remote control (RC-1109) ........................................................ 1
w R03/AAA batteries ................................................................... 2
e Power cord (Cord length: Approx. 6.6 ft /2 m) ......................... 1
r AM loop antenna ..................................................................... 1
t FM indoor antenna .................................................................. 1
y Owner’s manual ...................................................................... 1
u Service station list ................................................................... 1
Thank you for purchasing this DENON product. To ensure proper
operation, please read this owner’s manual carefully before using the
product.
After reading them, be sure to keep them for future reference.
• Before turning the power switch on
Check once again that all connections are correct and that there are
no problems with the connection cables.
• Power is supplied to some of the circuitry even when the unit is
set to the standby mode. When traveling or leaving home for long
periods of time, be sure to unplug the power cord from the power
outlet.
• Sufficiently ventilate the place of installation
If the unit is left in a room full of the smoke from cigarettes, etc., for
long periods of time, the surface of the optical pickup could get dirty,
in which case it will not be able to read the signals properly.
• About condensation
If there is a major difference in temperature between the inside of
the unit and the surroundings, condensation (dew) may form on
the operating parts inside the unit, causing the unit not to operate
properly.
If this happens, let the unit sit for an hour or two with the power
turned off and wait until there is little difference in temperature
before using the unit.
• Cautions on using mobile phones
Using a mobile phone near this unit may result in noise. If so, move
the mobile phone away from this unit when it is in use.
• Moving the unit
Turn off the power and unplug the power cord from the power
outlet.
Next, disconnect the connection cables to other system units before
moving the unit.
• Note that the illustrations in these instructions may differ from the
actual unit for explanation purposes.
Note:
For proper heat dispersal, do not install this unit in a confined
space, such as a bookcase or similar enclosure.
b Note
b Wall b
b
e
r t
q
Discs Usable on the RCD-CX1
q Super Audio CDs
Super Audio CDs marked with the logotypes indicated below can
be played on this unit.
There are three types of Super Audio CDs:
q
Single layer disc
Single layer Super Audio CD with only an HD layer.
w
Dual layer disc
Super Audio CD with a double HD layer, offering extended playing
time and high sound quality.
e Hybrid disc
Two-layer Super Audio CD with an HD layer and a CD layer.
The signals on the CD layer can be played on a regular CD player.
Get
ting Star
ted
Accessories
Getting Started
Cautions on Handling
About Discs
Cautions on Installation
Connections
Set
up
Pla
ybac
k
Set
ting the
Timer
Other F
unctions
Tr
oubleshooting
Specifications
1.RCD-CX1E3_ENG.indd 2 2008/06/30 11:12:24