Troubleshooting – Desa Air Conditioner User Manual

Page 7

Advertising
background image

www.desatech.com

113893-01B

7

POSSIBLE CAUSE

1. No electrical power to heater

2. Fan hitting inside of heater

shell

3. Fan blades bent

4. Defective motor

1. User did not follow installa-

tion or operation instructions

properly

2. No spark at spark plug. To test

for spark, follow step 8 under

Spark Plug, page 9. If you see

spark at spark plug, have heater

serviced by qualified service

person. If no spark seen:

A) Loose or disconnected

spark plug wire

B) Bad spark plug

C) Bad spark transformer

1. Propane supply may be inad-

equate

2. High surrounding air tem-

perature causing thermal limit

device to shut down heater.

3. Restricted air flow

4. Damaged fan

5. Excessive dust or debris in

surrounding area

REMEDY

1. Check voltage to electrical

outlet. If voltage is good,

check heater power cord for

breaks

2. Adjust motor/fan mount to

keep fan from hitting inside of

heater shell. Bend fan mount

if necessary

3. Replace fan. See Fan, page 8

4. Replace motor. See Motor,

page 8

1. Repeat installation and opera-

tion instructions. See Instal-

lation, page 4 and Operation,

page 5

2. A) Check spark plug wire.

Tighten or reattach loose spark

plug wire. See Figure 8, page 9

for spark plug wire location

B) Replace spark plug. See

Spark Plug, page 9

C) Replace spark transformer.

See Spark Transformer, page 9

1. A) Refill tank

B) Provide additional and/or

larger tanks. See Propane

Supply, page 4

2. This can happen when running

heater in temperatures above

85° F (29° C). Run heater in

cooler temperatures

3. Check heater inlet and outlet.

Remove any obstructions

4. Replace fan. See Fan, page 8

5. Clean heater. See Mainte-

nance, page 6

OBSERVED PROBLEM

Fan does not turn when heater

is plugged in

Heater will not ignite

Heater shuts down while run-

ning

TROUBLESHOOTING

WARNING: Never service heater while it is plugged in, connected

to propane supply, operating or hot. Severe burns and electrical

shock can occur.

WARNING: Use only in areas

free of high dust content.

Advertising