Datalogic Scanning GRYPHON GM4100 - Manual (Page 26)

Interface Selection
22 Gryphon™ I GM4100
Interface Selection
Each reader model will support one of the following sets of host
interfaces:
General Purpose Models: RS-232, RS-232 OPOS, USB, Key-
board Wedge
Retail Point of Sale Models : RS-232, RS-232 OPOS, USB, IBM
46XX
Configuring the Interface
Scan the programming barcode which selects the appropriate in-
terface type matching the system the reader will be connected to.
Next, proceed to the corresponding chapter in the Gryphon™ I
GD4100/GM4100 PRG to customize any settings and features
associated with that interface.
NOTE
Unlike some other programming features and options,
interface selections require that you scan only one
programming barcode label. DO NOT scan an ENTER/
EXIT barcode prior to scanning an interface selection
barcode.
Some interfaces require the scanner to start in the dis-
abled state when powered up. If additional scanner
configuration is desired while in this state, pull the
trigger and hold for 5 seconds. The scanner will change
to a state that allows programming with barcodes.
RS-232
RS-232 standard interface
Select RS232-STD
RS-232 Wincor-Nixdorf
Select RS232-WN