Kemppi FastMig Pulse 350 - Manual (Page 15)

EN
4.3 Welding parameters and functions
4.3.1 Welding parameters
MIG
WFSpeed 0.7 – 25 m/min 0.05 m/min steps when WFSpeed < 5 m/min and
0.1 m/min steps when WFSpeed > 5 m/min
WFS-Max Set the limit for maximum WFSpeed
WFS-Min Set the limit for minimum WFSpeed
Voltage 8.0 – 50.0V 0.1V steps Controls the length of the arc
VoltageMax Set the limit for maximum voltage value
VoltageMin Set the limit for minimum voltage value
Dynamics -9 ... +9 Factory setting is 0 Controls the short circuit behaviour of the arc. The lower
the value the softer the arc is. The higher the value the
rougher the arc is.
1-MIG
WFSpeed 0.7 – 25 m/min * 0.05 m/min steps when WFSpeed < 5 m/min and
0.1 m/min steps when WFSpeed > 5 m/min
WFS-Max Set the limit for maximum WFSpeed
WFS-Min Set the limit for minimum WFSpeed
FineTuning -9.0 ... +9.0 Factory setting is 0.0
( = curve point)
0.5 steps Adjusts the arc voltage of the curve within certain
limits. In other words, it adjusts the length of the arc
within certain limits
FineTuningMax -9.0 ... +9.0 0.5 steps Set the limit for maximum arc length
FineTuningMin -9.0 ... +9.0 0.5 steps Set the limit for minimum arc length
Dynamics -9 ... +9 Factory setting is 0 Controls the short circuit behaviour of the arc. The lower
the value the softer the arc is. The higher the value the
rougher the arc is.
PULSE MIG
WFSpeed 0.7 – 25 m/min * 0.05 m/min steps when WFSpeed < 5 m/min and
0.1 m/min steps when WFSpeed > 5 m/min
WFS-Max Set the limit for maximum WFSpeed
WFS-Min Set the limit for minimum WFSpeed
FineTuning -9.0 ... +9.0 Factory setting is 0.0
( = curve point)
0.5 steps Adjusts the base current of the curve in certain limits.
In other words, it adjusts the length of the arc in certain
limits.
FineTuningMax -9.0 ... +9.0 0.5 steps Set the limit for maximum arc length
FineTuningMin -9.0 ... +9.0 0.5 steps Set the limit for minimum arc length
Dynamics -9 ... +9 Factory setting is 0 Controls the short circuit behaviour of the arc. The lower
the value the softer the arc is. The higher the value the
rougher the arc is.
Pulse Current -10% ... +15% Factory Setting
is 0% Reduces the pulse current of the curve at the maximum
10% and raises it at the maximum 15%.
13
© Kemppi Oy / 1515