Kleenmaid GCTE6010 User Manual
Page 5
5
change the minutes in the same way described for the
hours.
When you press PT, the time setting will be saved.
Unlocking the burners
When a burner is locked, the relative display shows the
letter “b”. To unlock, hold down the burner A key and
the KL key for at least 2 seconds. After being unlocked,
the burners will be reset to level 0, ready to be turned
on again.
Note: If you have to repeat the unlock procedure 5
consecutive times in a period of 15 minutes, the device
will display FT06 and will not allow any more unlocks for
another 15 minutes.
Locking the keypad
This is activated by pressing just the KL key for at least 2
seconds. All the burners will remain at the current level.
The status of the keypad is indicated by the lighting of the
decimal points in the flow level displays for each burner.
When the keypad is locked, it is not possible to change
the levels of the burners or change the timer settings but
it is possible to turn off the surface by pressing the ON/
OFF key.
It is not possible to unlock a locked burner while the
keypad is locked. For this reason, you must unlock the
keypad before unlocking the burners.
Unlocking the keypad
To unlock the keypad, press the KL key and the + key
of burner A for at least 2 seconds. When the keypad is
unlocked, the decimal points in the level displays turn
off.
Residual Heat
When a burner goes out, the relative display shows an
"H" to indicate that the temperature of that burner is still
high and the relative LED near the timer display remains
on.
The "H" symbol and the LED turn off when the
temperature of the relative burner is cool.
Special slow cooking (Duty cycle)
This function turns any cook top burner on and off is the
sequence shown in the table.
LEVEL SET.
1
2
3
4
5
TURN-OFF TIME
10
Sec.
20
Sec.
30
Sec.
40
Sec.
50
Sec.
TURN-ON TIME
50
Sec.
40
Sec.
30
Sec.
20
Sec.
10
Sec.
The function is activated by pressing the + key of the
burner you want to apply it to, and the PT key (the burner
involved must be off when this function is activated).
The burner turns on at level 3 and, at that time, you can
set the level to apply the function to by pressing the +
and - keys.
If, for example, you set the value to level 1, the burner
will remain on for 50 seconds, then it will turn off for 10
seconds and repeat this cycle until you turn the burner
off.
If the user does not intervene it turns off automatically
after 60 minutes. When this function is active the display
A
of the relative burner flashes.
Warning
Do not use or store flammable materials near this appliance.
Do not spray aerosols in the vicinity of this appliance while it
is in operation.
Do not modify this appliance.
Where this appliance is installed in a marine craft, caravan
or mobile home. It shall not be used as a space heater.