Kleenmaid GCTE6010 - Manual (Page 8)

8
Instructions for the installer
Installation
This appliance is not provided with a combustion
product discharge. It is recommended that it be installed
in sufficiently aerated places, in terms of the laws in force.
The quantity of air which is necessary for combustion
must not be below 2.0 m 3 /h for each kW of installed
power. See table of burner power.
Positioning (Fig. 5)
The cook top is designed to be built in to a work surface
as shown in the figure.
Before installing the cook top, install the gasket seal
around the entire perimeter of the hole where it will be
inserted.
The dimensions of the hole are shown in figures 6-7-8-9.
For Filotop models, the perimeter of the hole must be
lowered by a depth of 1.5 mm.
The hole does not need to be milled for Semifilotop
models.
The cook top can be installed on different materials such
as brickwork, steel, marble, conglomerates, synthetics,
wood and wood covered with plastic laminates, so long
as resistant to a temperature of 90 °C.
Fig. 5
A panel made of wood or other insulating material
must be installed under the cook top at a distance
of at least 15 mm from the surface.
Range hoods and exhaust fans shall be
installed in accordance with the
manufacturer’s relevant instructions.
However, in no case shall the clearance
between the highest part of the hob of the
gas cooking appliance and a range hood
be less than 600 mm or, for an overhead
exhaust fan, 750 mm.