Manufactured (mobile) home installation, Warning – Kleenmaid LEK37A Version 506066R4 User Manual

Page 16

Advertising
background image

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Installation

506066

14

Manufactured (Mobile) Home
Installation

The dryer can be installed in a manufactured (mobile)

home by following these instructions:

1. IMPORTANT: Gas dryers MUST be

permanently attached to the floor at the time
of installation. Order No. 526P3 Dryer
Installation Kit for a manufactured (mobile)
home installation. Follow the instructions
supplied with the kit.

2. Venting – Dryer MUST be exhausted to the

outdoors.

The dryer can be exhausted to the outdoors

through the back, left, right or bottom panel. Gas

dryers cannot be exhausted out the left side

because of the burner housing.

The dryer exhaust duct must be secured to the

mobile home structure.

Exhaust ducts MUST NOT be connected with

sheet metal screws or fasteners which extend into

the duct.

Exhaust duct must not be connected to any other

duct, vent or chimney.

Dryer exhaust duct MUST NOT terminate under

the mobile home.

For proper operation, it is important that the dryer

has an ample amount of outside make-up air. The

free area of any opening for the introduction of
outside air must be at least 163 cm

2

(25 in

2

).

When exhausting the dryer to the outdoors, the

dryer can be installed with “0” inch clearance at

the sides and rear. Clearance of the duct from

combustible construction must be a minimum of

5.08 cm (2 inches).

Venting materials are not supplied with the dryer

(obtain locally).

IMPORTANT: Installation must conform
to the Manufactured Home Construction
and Safety Standards, Title 24 CFR, Part
32-80 or Standard CAN/CSA-Z240 MH.

To reduce the risk of fire and combustion
gas accumulation, the dryer MUST BE
EXHAUSTED TO THE OUTDOORS. Refer to
Section on Dryer Exhaust Requirements.

W047

WARNING

To reduce the risk of fire, the exhaust duct
and weather hood MUST be fabricated of a
material that will not support combustion.
Rigid or flexible metal pipe is recommended
for a clothes dryer.

W048

WARNING

Advertising
This manual is related to the following products: