Kleenmaid LEK37A Version 506066R4 - Manual (Page 24)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
506066 22
Exhaust Direction
The dryer can be exhausted to the outdoors through the
back, left, right or bottom of the dryer. EXCEPTION:
Gas dryers cannot be vented out the left side
because of the burner housing.
Dryer is shipped from factory ready for rear exhaust;
no kits required
.
Exhausting the dryer through sides or bottom can be
accomplished by installing Directional Exhaust Kit,
528P3, available as optional equipment at extra cost.
IMPORTANT: Do not block the airflow at the
bottom of the dryer’s front panel with laundry,
rugs, etc. Blockage will decrease airflow through
the dryer, thus reducing the efficiency of the dryer.
Figure 15
D328IE0A
D328IE0A
528P3 DIRECTIONAL EXHAUST KIT
Number of
90° Elbows
Weather Hood Type
Recommended Use Only for Short Run Installations
Maximum length of 10.2 cm (4 in.) diameter rigid metal duct.
0 19.8 m (65 feet) 16.8 m (55 feet)
1 16.8 m (55 feet) 14.3 m (47 feet)
2 14.3 m (47 feet) 12.5 m (41 feet)
3 11.0 m (36 feet) 9.1 m (30 feet)
4 8.5 m (28 feet) 6.7 m (22 feet)
Maximum length of 10.2 cm (4 in.) diameter flexible metal duct.
0 13.7 m (45 feet) 10.7 m (35 feet)
1 10.7 m (35 feet) 8.2 m (27 feet)
2 9.1 m (30 feet) 6.4 m (21 feet)
3 7.6 m (25 feet) 5.2 m (17 feet)
4 6.1 m (20 feet) 4.5 m (15 feet)
NOTE: Deduct 1.8 m (6 feet) for each additional elbow.
Table 3
10.2 cm
(4 in.)
10.2 cm
(4 in.)
D673I
6.35 cm
(2-1/2 in.)
D802I