Kiddy World plus - Manual (Page 38)

37
7.3 Removal and assembly of protection shield
7.3.1 Removing the protection shield
To remove the protection shield for booster car
seat use mode, turn the car seat to it’s back.
Take a Phillips screwdriver (not included) and
remove both screws securing the LATCH lower
anchor belt (Fig. 57).
Next, pull out the plastic anchor, which is fixed
into the back of the car seat (Fig. 58).
Now you can remove the protection shield and
the lower anchor belt with LATCH connectors
from the seat.
Store all removed parts out of children's reach and save for future use in case
you wish to use the car seat again for child weighing less than 40 lb (18 kg)
(protection shield required).
To assemble the seat with the protection shield and lower anchor belt with
latch connectors, follow the steps in section 7.3.2.
7.3.2 Assembling the protection shield
Locate the protection shield with LATCH lower
anchor belt screws and plastic anchors from front
of car seat, place protection shield into protection
shield slots (Fig. 59).
• Protection shield must be used with children 22 to 40 lb (10 to 18 kg).
• Do not use a protection shield with children over 40 lb (18 kg).
• Prevent choking - screws and plastic anchors are small parts when
removed and can pose a choking hazard. Keep these parts out of
children's reach.
Fig. 57
Fig. 58
Fig. 59
WARNING
! DEATH or SERIOUS INJURY can occur