Basic maintenance and care, Fitting the rear wheel – Koga NuVinciHarmony - E-Nova NuVinci User Manual
Page 8
Owner manual
8
EN
Fitting the Rear Wheel
Place the rear wheel into the frame,
making sure not to obstruct or pinch
the Harmony or Harmony H|Sync
wire harness and Main Connector.
Orient the chain around the Harmony
or Harmony H|Sync Hub Interface and
onto the sprocket.
In some cases, it is easiest to remove
the chain from the front chain ring to
ease rear wheel installation.
Slide one no-turn washer (3) onto
each axle end. The serrations of the
no-turn washer must bear against the
dropout of the frame. The rectangular
boss must engage the dropout of
the frame.
Mount the axle nuts (2). Tightening
torque 30 - 40 Nm (266-350 in lbs).
For rim and roller brake applications,
connect the rear brake according to
the manufacturer’s instructions.
Install the Harmony or Harmony
H|Sync Main Connector by lining
up the arrows (5) and carefully
pressing together.
4
5
6
7
4
Basic Maintenance and Care
2
2
3
3
5
4
4
Note location of wheel speed
sensor (4) at rear wheel - the
chain should not catch on this
sensor when fitting the wheel.
5-6
7