La Crosse Technology WS-3610 User Manual
Page 28
25
Important:
To avoid operating problems, please take note of
battery polarity if inserting any batteries. Also do not press any
buttons after start up until all sensor information has been
displayed and the radio controlled time has set. Doing so may
interrupt communication between the sensors and display or
interrupt the WWVB time reception.
1. Pull away the rain cover of the thermo-hygro sensor to
reveal the three sockets (for the wind sensor, rain sensor
and the base station)
2. Connect the attached cables of wind and rain sensors to the
corresponding sockets of the thermo-hygro sensor by
clicking them into place
3. Open the battery cover of the thermo-hygro sensor located
below the three sockets and insert 2 x AA, IEC LR6, 1.5V
batteries and close the cover
4. Open the base station’s battery cover located at the back of
the unit and insert 3 x AA, IEC LR6, 1.5V batteries into the
battery compartment and close the battery cover
Every time the thermo-hygro sensor is powered up (for example
after a change of batteries), a random security code is
transmitted and this code must be synchronized with the base
station to receive weather data.
Note for WWVB Radio Controlled Time:
The time and date display is based on the signal provided by the
highly accurate government operated atomic clock in Ft. Collins,
Colorado. This radio-controlled clock does not only provide for
the weather station’s time and date display but also functions as
the time and date source for all of this weather station’s memory
values using time and date information.