La Crosse Technology WS-9065TWC User Manual
Page 14
14
2. Press
the
OUT button again (once while “MIN” is still
displayed, twice otherwise). “MAX” appears above the outdoor
temperature and the LCD will flash, indicating that the
maximum temperature and the time and date of occurrence are
displayed.
3.
While “MAX” is still displayed press the OUT button again to
return to the current data display. Or you can wait 30 seconds,
during either the minimum or the maximum readings, and the
unit will automatically return to current data readings.
C. RESETTING THE MIMIMUM AND MAXIMUM RECORDS
1.
All the Indoor records (minimum and maximum) will be reset after
the IN button is pressed and held for 5 seconds.
2.
All the Outdoor records (minimum and maximum) will be reset after
the OUT button is pressed and held for 5 seconds.
V. ADDING REMOTE TEMPERATURE SENSORS (OPTIONAL)
The WS-9065U is able to receive signals from 3 different remote temperature
sensors. The remote temperature sensor model(s) that you choose will come with
their own set of instructions—follow these instructions for a complete guide to
setting up. Following are some brief instructions for the basic set-up of remote
temperature sensor units with the WS-9065U. These extra sensors can be purchased
through the same dealer as this unit, or by contacting La Crosse Technology
directly. A TX6U will monitor temperature only, a TX3U will monitor temperature
and display the temperature on its LCD, and the TX3UP will monitor the
temperature via a probe for use in pools, spas, etc.
Note: When setting up multiple units it is important to remove the batteries from all
existing units in operation, then to insert batteries first into all the remote
temperature sensor units, and in numeric sequence. Second install batteries into the
indoor weather station. Transmission problems will arise if this is not done correctly
and if the total time for set-up exceeds 6 minutes.
A. SET-UP OF MULTIPLE UNITS
1.
It is necessary to remove the batteries from all units currently in
operation.
2.
Remove the battery covers to all remote temperature sensor units.
3.
Place all remote temperature sensor units in a numeric sequential
order.