La Crosse Technology WS-9065TWC - Manual (Page 17)

17
II. THE INDOOR WEATHER STATION
The indoor temperature station can be mounted in two ways:
•
with the table stand or
•
on the wall with the use of a wall hanging screw (not
included).
A. USING THE TABLE STAND
1) The indoor temperature station comes with the
table stand already mounted. If you wish to
use the table-stand all that is required is to
place the indoor temperature station in an
appropriate location.
B. WALL MOUNTING
1) Remove the table stand. To do this, pull
down on the stand from the rear and rotate
forward.
2) Fix a screw (not included) into the desired
wall leaving approximately 3/16 of an inch
(5mm) extended from the wall.
3) Place the indoor temperature station onto the screw using the
hanging hole on the backside. Gently pull the station down
to lock the screw into place.
TROUBLESHOOTING
NOTE: For problems not solved, please contact La Crosse Technology.
Problem: No reception of WWVB time signal.
Solution: 1) Wait overnight for signal.
2) Be sure Weather Station is at least 6 feet from any electrical devices, such as
televisions, computers, or other radio-controlled clocks.
3) Remove batteries for five minutes, reinsert and leave the unit alone overnight
without pressing buttons.
4) If there are still problems, contact La Crosse Technology
Problem: Hour is incorrect (minute and date are correct)
Solution: Be sure correct time zone and daylight saving time settings are selected.
Problem: The LCD is faint
Solution: 1) Set the LCD contrast to a higher number
2) Replace batteries