Local codes, Unpacking, Product features – Desa EFS33PRB User Manual

Page 5: Air for combustion and ventilation

Advertising
background image

www.desatech.com

113132-01B

5

LOCAL CODES

Install and use fireplace with care. Follow all local

codes. In the absence of local codes, use the lat-

est edition of The National Fuel Gas Code ANSI

Z223.1/NFPA 54*.
*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

Note:

Where listed vented decorative logs are

required, thermostat operation is not permitted.

UNPACKING

CAUTION: Do not remove the

data plates attached to the heater

base assembly. The data plates

contain important warranty and

safety information.

1. With utility knife, cut the carton all the way

around above the staples on the bottom tray.

Lift the carton off the heater. Remove packing.

Note:

The hood is located in the packing on

the right hand side of the heater front. Lift the

heater off the bottom tray.

2. Locate two screws above top corners of the

fireplace screen. Remove and discard these

screws. Lift fireplace screen up and pull out to

remove.

3. Remove protective packaging applied to logs,

log base assembly, and fireplace.

4. Remove fireplace hood from carton insert.
5. Check all items for any shipping damage. If

damaged, promptly inform dealer where you

bought fireplace.

PRODUCT FEATURES

OPERATION

This vent-free fireplace is clean burning. It requires

no outside venting. There is no heat loss out a vent

or up a chimney. Heat is generated by both realistic

flames and glowing embers. When used without the

optional blower, the fireplace requires no electricity

making it ideal for emergency backup heat.

SAFETY DEVICE

This fireplace has a pilot with an Oxygen Depletion

Sensing (ODS) safety shutoff system. The ODS/

pilot is a required feature for vent-free room heat-

ers. The ODS/pilot system shuts off the fireplace

if there is not enough fresh air.

PIEZO IGNITION SYSTEM

This fireplace has a piezo ignitor. This system

requires no matches, batteries, or other sources

to light fireplace.

OPTIONAL REMOTE CONTROL
ACCESSORY

There are four optional remote controls (not in-

cluded) that can be purchased separately for this

log heater:
• wall switch

• wall thermostat

• hand-held ON/OFF remote

• hand-held thermostat remote

See Accessories, page 32.

OPTIONAL BLOWER ASSEMBLY
ACCESSORY

This fireplace accepts an optional blower assembly

(not included). The GA3650T Series blower oper-

ates thermostatically and features a variable speed

control. The GA3750 Series operates manually

and also features a variable speed control. The

blower circulates heated air from the fireplace

into the room. Use of blower is optional. See Ac-

cessories, page 32.

AIR FOR COMBUSTION

AND VENTILATION

WARNING: This heater shall

not be installed in a confined

space or unusually tight construc-

tion unless provisions are provid-

ed for adequate combustion and

ventilation air. Read the following

instructions to insure proper fresh

air for this and other fuel-burning

appliances in your home.

Todayʼs homes are built more energy efficient

than ever. New materials, increased insulation, and

new construction methods help reduce heat loss

in homes. Home owners weather strip and caulk

around windows and doors to keep the cold air out

and the warm air in. During heating months, home

owners want their homes as airtight as possible.

Advertising