Legrand Wallduct Medical Raceway System Bodies - Manual (Page 8)

Step 2 For Flush to Surface Transition – With
coverplate area prepared, apply grommet to
all sharp edges, place wires and wire retainers,
and attach transition with planut clips and
#10-32 machine screws provided.
Step 1 For Sweep Tees – Remove cover of sweep
tee unit and save screws. Attach unit to duct
body using coupling angles and #10-32
taptite screws provided. Refer to page 2 for
similar mounting methods.
Step 2 For Sweep Tees – Attach unit to the other duct
body using #10-32 machine screw and palnut
clips provided. Refer to instructions shown in
step 2 of previous page for attachment method.
SPECIFIC INSTRUCTIONS: FLUSH TO SURFACE TRANSITIONS AND SWEEP TEES
Flush to Surface transitions are used for changing covers of duct bodies to a flush or surface application. Sweep
tees are used for changing directions of the duct body or adding a perpendicular duct in the middle or at the end
of a straight duct.
Step 1 For Flush to Surface Transition – In desired
location, field cut cover to allow for transition
to fit onto duct body. Refer to instructions
shown in step 2 of previous page for
attachment method.