Legrand MRH6 - Manual (Page 2)

more sCenes
Up to 15 scenes are available per room, in sets of 1‑5, 6‑10, and 11‑15. The
MRH6 can access sets 1‑5 or 6‑10. It is assigned to scenes 1‑5 when shipped.
Binding multiple room level controllers (MRH6, MRD6, or DRD6) to the room and
assigning each to a different scene set, lets you dedicate a controller to each
scene set. You can bind more room scene controllers to the
room to control the same scenes from multiple locations.
All room scene controllers with the same scene assignment
operate the 5 scenes the same way as all other room scene
controllers with the same set. Scene buttons on controllers
with scene set 6‑10 default to 0%/All room devices OFF. Use
ROOM BINDING and CUSTOMIZING OPERATION procedures
to set up the additional scene controllers.
To assign scenes 6-10, simultaneously press and B until
the LED blinks twice (about 2 seconds).
To change the assignment back to scenes 1-5, simultaneously press and a
until the LED blinks twice (about 2 seconds).
LoCk room ConFiguration
The Lock Configuration function operates from a wireless room level controller,
and prevents the Miro wireless devices in the room from being reprogrammed.
Other operations such as dimming, switching and scene recall are not affected.
When the configuration is locked, if is pressed and held on any Miro wireless
device, the device’s LED flashes red and the command is ignored.
to lock the configuration:
Go to any room scene controller. Simultaneously press
and buttons B and e until the LED flashes (about 2 seconds)
to toggle in and out of Lock Configuration.
• If the mode changes from unlocked to locked, the LED
flashes red for 2 seconds, indicating that configuration is
now locked.
• If the mode changes from locked to unlocked, the LED
flashes green for 2 seconds, indicating that configuration is now unlocked.
BatterY inFormation
The MRH6 operates using three 1.5V Alkaline AAA size batteries. The remote
goes to sleep whenever it is not performing a function. When asleep, its LED is
off. To check battery status, press any button to wake up the remote.
important: Observe the color of the LED immediately after you wake it up.
• green indicates the batteries are good.
• reD indicates the batteries are getting weak and should be replaced.
ROOM REMOTE
4 FINGERS
A
E
D
C
B
52205(027(
),1*(56
$
(
'
&
%
Assigning the MRH6
for scene set 6‑10