Marantz SR4300N - Manual (Page 13)

10
ENGLISH REMOTE CONTROLE UNIT
OPERATION
The supplied remote control unit is a system remote control unit for
Marantz AV components.
The POWER button , numeric buttons and control buttons are used in
common across different input source components.
The input source controlled with the remote control unit changes when
one of the input selector buttons is pressed.
• Example: To select the DVD as the input source and play the DVD
player.
Press the DVD button twice within 2 seconds.
The input selector of the SR4300 is switched to DVD and
the remote control unit is set for control of the DVD
player.
Press the
button on the remote control unit.
FUNCTION AND OPERATION
z Infrared window
Outputs and inputs an infrared control signals.
x MEMO(Memory) button
Press this button to enter the tuner preset memory numbers and
station names.
c POWER button
Press to switch the power of the SR4300 ON or OFF after pressing the
AMP button.
v TREBLE (Up) / (Down) buttons
These buttons are used to adjust the tone control of high frequency
sound for left and right speakers.
b BASS (Up) / (Down) buttons
These buttons are used to adjust the tone control of low frequency
sound for left, right and subwoofer speakers.
n F.(Frequency) DIRECT button
Press this button to change tuner mode Frequency Direct Call.
m SETUP / T.TONE button
Test tone function is used for adjusting the balance between the
volume levels of speaker channels.
Press AMP button and press this button to call SPEAKER LEVEL
setup menu.
Press the button again to stop the pink noise generation.
, S- ( Source) DIRECT button
When this button is pressed, the tone control circuit is bypassed as
well as Bass Management.
. MUTE button
Press this button decrease the sound temporarily .
Press this button again to return to the previous sound level.
⁄0 NIGHT button
Pressing this button prevents the Dolby Digital signal from playback at
a loud voice. This function reduces the voice by 1/3 to 1/4 at
maximum. Thus, it eliminates the occurrence of an abruptly loud voice
at night.
⁄1 Input selector buttons/ FUNCTION
SELECTOR buttons for VIDEO component
⁄2 Input selector buttons/ FUNCTION
SELECTOR buttons for AUDIO component
Press one of these buttons once or twice to select a particular source
component. For example, to set the receiver to the DVD input, press
the DVD button twice within 2 seconds.
⁄3 AMP button
To select the surround mode of the SR4300, press this button
previously.
⁄4 CLEAR button
Press this button to cancel the station memory setting mode or preset
scan tuning.
⁄5 SLEEP (sleep timer) button
This button is used for setting the sleep timer. It can be operated the
same way as the button in unit.
SYSTEM REMOTE CONTROLLER RC4300SR
POWER
VCR1
DVD
TAPE
MD
OFF
SLEEP
CLEAR
TREBLE
OK
CHANNEL/SKIP
CS
ATT.
MEMO
2
TV CDR
BASS
1
4
8
5
9
6
3
7
0
MENU
VOLUME MUTE
CD
AMP
AUTO DTS
DSP
6.1CH
-IN
2CH
EX/ES
M-CH
ST
A/D
TUNE/SEARCH
NIGHT
TUNER
SETUP/T.TONE
S-DIRECT
MODE
DISP./RDS
PTY
P.SCAN VCR2
DSS
F.DIRECT
c
x
z
v
b
n
m
,
⁄1
⁄2
⁄3
.
¤2
¤0
⁄5
⁄0
¤1
⁄6
⁄9
⁄8
⁄7
⁄4