Marantz SA-14S1N - Manual (Page 32)

25
ENGLISH
Play File
Sets the playback range of files recorded on the disc or a USB
memory device.
Disc
Selects whether all files or files within a specific folder are to
be played during a disc playback.
All (Default) : All files on the Disc are played.
Folder : Files within a selected folder are played.
USB
Selects whether all files or files within a specific folder are to
be played during a USB memory device playback.
All (Default) : All files on the USB memory device are played.
Folder : Files within a selected folder are played.
Disp Info
Sets the information displayed during iPod or USB memory
device playback.
iPod
Sets the information displayed during iPod playback.
Time (Default) : Displays the time information.
Title : Displays the title name.
Artist : Displays the artist name.
Album : Displays the album name.
Press INFO to switch the information during playback.
USB
Sets the information displayed during USB memory device
playback.
Time (Default) : Displays the time information.
Title : Displays the title name.
Artist : Displays the artist name.
Album : Displays the album name.
Press INFO to switch the information during playback.
iPod Ctrl
Specifies whether iPod operation is to be performed from the
unit or at the iPod.
Direct (Default) : Control using the iPod.
Remote : Control using this unit and the remote control.
USB Resume
This unit stores the point at which playback of a file was
stopped previously, and starts playback from the same point
the next time playback is started.
On (Default) : Resume playback is set.
Off : Resume playback is not set.
NOTE
• Resume playback works even if the USB memory device is
disconnected and then reconnected. However, if a different
USB memory device is connected, the resume information
for the previous USB memory device is deleted.
• The resume information may be deleted when the USB
memory device is removed and files are added or deleted.
Digital Out
Setting for the digital output.
On (Default) : Enable the digital output.
Off : Disable the digital output.
Auto Stnby
A standby status is established at the unit if a stopped status
or a no external input signal status continues for 30 minutes
or more.
On (Default) : Enable Auto Standby mode.
Off : Disable Auto Standby mode.