Marantz VP8000 - Manual (Page 17)

16
OPERATIONS
ENGLISH
LAMP LIFE
You can display the lamp life remaining at any time. Press the
OSD key on the remote controller.The menu appears. LAMP
LIFE is on the bottom line of the menu.
Notes
• When the LAMP LIFE is less than 1000 HOURS, it is
recomended to replace the lamp unit. A lamp may be worn-
out when the LAMP LIFE is less than 1000 HOURS.
• The projector is designed not to turn on after the lamp use
has exceeded 2000 hours. (LAMP LIFE 0 HOUR)
If the projector is in use, it will turn off.
Ǡ Ǡ When the lamp expires in about 100 hours, the lamp life
remaining is displayed on the screen when the projector is
on.
Ǡ Ǡ When the lamp life expires in about 5 hours, the limp life
remaining is displayed on the screen at one hour interval.
To clear the menu above, press the MENU key.
WARNING
LAMP LIFE 5 HOURS
WARM UP
LAMP LIFE 100 HOURS
VIDEO INPUT :COMPONENT
VIDEO SETTING :NORMAL STD
DIG-ZOOM :OFF
SMOOTHING :OFF
NOISE REDUCTION :OFF
WHITE ENHANCER :OFF
ASPECT
:SQUEEZE
OSD MODE :WIDE
LAMP LIFE :1125HOURS
Ǡ Ǡ When the lamp life has expired (LAMP LIFE 0 HOURS), the
projector will be immediately turned off and the WARNING
indicator will blink in orange.
Use the following procedure to reset (initialize) the lamp life
indicator when replacing the lamp with a new one:
1. Unplug the power cord.
2. Wait about one minute and reconnect the power cord.
3. Press the POWER key. Only the POWER key will be of
effect. The following message appears for 120 seconds.
4. Select "YES", using the ǡ/Ǡ keys.
5. Press the ENTER key. The lamp life indicator is now
initialized.
REPLACE LAMP！
RESET LAMP LIFE YES NO
WARNING
LAMP LIFE 0 HOUR
Lamp Life and Replace Lamp