Marantz AS6150 - Manual (Page 3)

3
50mm/1.97inch
50mm/1.97inch
50mm/
1.97inch
50mm/
1.97inch 50mm wall
Always Heed the Following
NOTES
CAUTIONS
- Do not obstruct the Plasma Display’s ventilation holes.
If the ventilation holes are covered, the heat will build up inside, and this could lead to fire.
For example, do not install the Plasma Display in narrow spaces where ventilation is poor, do not place covers over it, etc.
- Do not install the Plasma Display near air conditioner air outlets or in places where vibrations are strong.
Doing so could lead to fire or electric shock.
- Do not install the Plasma Display in humid or dusty places or places exposed to soot or vapor (such as in kitchens,
near humidifiers, etc.). Doing so could lead to fire.
Do not install the Plasma Display outdoors. Doing so could lead to fire or electric shock.
Avoid dusty or humid rooms and rooms filled with soot or cigarette smoke.
The Plasma Display’s screen could get dirty, resulting in poor picture quality.
Avoid places where the screen is exposed to direct sunlight or strong artificial light.
If surrounding light should shine on the screen, the screen will appear white and be hard to see.
Do not install in places where the temperature is high or low.
Doing so could result in damage.
- Hold the Plasma Display securely when mounting the units on it. Failure to do so could cause the Plasma Display to
fall, resulting in injury.
- When installing the Plasma Display on a stand with casters, be sure to block the casters. If the stand should move,
the Plasma Display could fall, resulting in injury.
- The Plasma Display is heavy, so be sure to install in a stable place and take measures to prevent it from tipping over
and causing injury.
The Plasma Display has a high center of gravity. It should be unpacked and moved by a minimum of two people,
holding it at the top and bottom. Failure to do so could cause the Plasma Display to fall, resulting in injury.
- When installing the Plasma Display, leave sufficient space around it, as shown
in the diagram. Failure to do so could cause heat to build up inside, leading
to fire.
Additional fall prevention measures
- Either use the tip prevention fitting included with the display to fix the
plasma display to a wall, pillar or other strong place or use the holes on
the back on the stand to fix to a table, etc..(Do no use with the separately
sold ceiling mount unit or wall mount unit.)
- Pay attention to the rope when moving the Plasma Display.
- The screws for fastening the display to the wall, a pillar or a stand are not
included. Please obtain screws suited for the surface on which the display is
to be mounted.