Maytag MDB6100AWB Installation - Manual (Page 3)

TIP: Pre-measure cabinet height to that of the dishwasher. Dishwasher should be 1/4" lower than that of the cabinet opening.
It's easier to adjust the dishwasher outside the cabinet than inside.
UNCRATING UNCRATING
Prepare cabinet as needed. Electrical and water facilities should enter cabinet opening on the floor, or through the back or side walls,
as shown in the shaded portion of the drawing. Preferred drain outlet is shown in the upper portion of the cabinet in drawing
below. Care should be taken to route plumbing away from the motor. DO NOT make connections until dishwasher is in position.
Care should be taken to make sure cabinet holes for power cord and hoses have no sharp edges.
CABINET PREPARATION CABINET PREPARATION
Dishwashers come with pre-installed panels. Optional panels available: stainless steel trim kits
for wood panels and side panel kits. See your authorized selling dealer for a complete list of
products available. OPTIONAL PANELS AVAILABLE
TOOLS NECESSARY FOR INSTALLATION TOOLS NECESSARY FOR INSTALLATION
SUPPORT ACCESSORIES:
3/4" UL Approved Strain Relief
(provided)
2 Appropriate Sized Wire Nuts
3/8" Male (N.P.T.) Compression Elbow
or Flare Elbow
Thread Sealing Tape or Pipe Thread Compound
Appropriate Sized Hose Clamp
2 Wood Mounting Screws
(provided)
Water Hook-Up Kits Available:
(Water line, water valve fitting, Teflon™ tape, tee valve fitting)
5’ Braided Stainless Steel Part #19950153
5’ Copper Part #19950152
Available through an authorized Parts Retailer
Remove access and toe panels before beginning installation.
Remove and discard base and packaging. Until dishwasher is permanently installed,
beware of opening the door as the unit may tip for ward.
Open the door and remove accessor y package from silver ware basket.
Remove any extra packing material from outside and inside the dishwasher.
Adjust front and rear leg bolts to installation height.
cabinet opening
Sta
rt Here
CUTTING KNIFE
RATCHET
3/16" and 1/4" SOCKETS
PHILLIPS SCREWDRIVER
STANDARD SCREWDRIVER
WIRE CUTTERS
CRESCENT WRENCH
ADJUSTABLE PLIERS
LEVEL
NOTE: Make sure you have everything
necessary for proper installation before
going to step 2.
dishwasher dimensions
Door Panel
Access Panel
Toe Panel
23 7/8
22 3/4"
33 3/4" (Min.)
35 1/4" (Max.)
(Not included: Tools required for preparing
the cabinet opening).
3”
24
”
24”
Keep back free
of drain, water &
electrical supply Preferred
Drain Area
8”
3” 5”
5”
7”
Preferred
Drain Area
34-35”
3