Dish Network Solo 311 - Manual (Page 20)

Page 15
Control Other Devices with the Remote
Page 15
C ONTROL A T UNER OR A MPLIFIER
AUX M ODE B UTTON
To use the remote to operate a tuner or amplifier, first set up the
remote to control the device, then press the AUX mode button to set
the remote to AUX mode. The AUX mode button’s backlight turns
ON to show that the remote is set to AUX mode. Make sure to keep
the remote in AUX mode to use the buttons as described in this
section.
P OWER B UTTON
Press the blank POWER button to turn the tuner or
amplifier ON or OFF.
S ELECT B UTTON
This SELECT button works as the Input Select button for a
tuner or amplifier.
U P /D OWN (A RROW ) B UTTONS
Use UP/DOWN ARROW buttons to change channels on
the tuner or amplifier.
M UTE B UTTON
Press the MUTE button to turn off the sound. Press it again to
restore the sound.
V OLUME B UTTON
Press the minus (-) side of this button to lower the sound
volume. Press the plus (+) side of this button to raise the
sound volume.
Note : See Using TV or Amplifier Volume Control to set up the remote
control to use the MUTE and VOLUME buttons.
Some of the features described below may not apply to your tuner or
amplifier. See the device owner’s manual for details about the device’s
features. If a remote control button is not described in this section, it
does not work for a tuner or amplifier.