Denon AVR-3300 - Manual (Page 35)

35
ENGLISH
System call function
• The included remote control unit is equipped with a system call function for transmitting multiple remote control signals when a single button
is pressed (this is often referred to as a “macro” function).
This function can be used to turn on the amplifier’s power, select the input source, turn on the monitor TV’s power, turn on a source
component’s power and start playback, etc., all at the touch of a button.
(1) System call buttons
The buttons that can be used for the system call function are shown on the table below.
A series of up to 10 operations can be performed with the POWER ON and OFF buttons, and a series of up to 5 operations can be performed
with other buttons.
System call signals are already preset at the buttons indicated in the shaded section. System call signals can also be stored at any button on
the remote control unit, including the buttons in this section. (See page 36.)
Button
No.
transmissions
Stored
operation 1
Receiver
power on
Receiver
power on
Receiver
power on
Receiver
power on
Receiver
power on
Stored
operation 2
DVD player
(DVD)
power on
LD player
(VDP)
power on
TV power on
Video (VCR)
power on
Receiver
input source
switched to
CD
Stored
operation 3
Receiver
input source
switched to
DVD
Receiver
input source
switched to
VDP
Receiver
input source
switched to
TV/DBS
Receiver
input source
switched to
VCR-1
Stored
operation 4
TV power on
TV power on
TV power on
Stored
operation 5
Stored
operation 6
Stored
operation 7
Stored
operation 8
Stored
operation 9
Stored
operation 10
DVD player
(DVD)
playback
LD player
(VDP)
playback
Video (VCR)
playback
POWER OFF 10
POWER ON 10
DVD 5
VDP
TV/DBS
VCR-1
CD
5
5
5
5
The system call signals for the POWER OFF and
POWER ON buttons are transmitted from the
remote control unit approximately once every
second.
The signals for the other buttons (DVD, VDP, TV /
DBS, VCR-1 and CD) are transmitted approximately
once every 1.5 seconds.
(2) Using the system call function
1 Press the system call button.
• The LEARNED/TX LED flashes for 5 seconds.
CALL
2 Press the button at which the desired system call signals are
stored while the LEARNED/TX LED is flashing.
• The preset signals or the signals you have stored at that
button are transmitted in succession.
DVD
START LEARNED/TX
SPEAKER
TUNING
BAND TITLE MENU/GUIDE
MODE
MEMORY
USE/LEARN T.TONE MULTI OUTPUT SET UP
RETURN
STATUS
DISPLAY
ON SCREEN
DOLBY / DTS
SURROUND DIRECT
DSP SIMULATION 5CH STEREO STEREO
INPUT MODE ANALOG EXT.IN
MUTING
MASTER VOL.
VOLUME DISC SKIP+
SYSTEM CALL POWER
VDP TUNER SHIFT
TV/DBS PHONO
VCR-1 CD MD / TAPE CHANNEL
VCR-2/V.AUX TV/VCR
AVR/AVC VIDEO DVD TV
AUDIO
VDP VCR
CD
MD
MULTI
DECK
SYSTEM SETUP SURROUND PARAMETER
CH SELECT
SELECT
RC-860
1 2 3
4
SET
A / B
CALL OFF
ENTER
ON / SOURCE
5 6
7 8 9
+10 0
2
1