Microsonic mic+25/DDIU/TC - Manual (Page 3)

*B8269*
MV-DO-096623-231470
Technical data
Blind zone
Operating range
Maximum range
Angle of beam spread
0 to 30 mm
250 mm 0 to 60 mm
350 mm
350 mm
Please see detection zone 600 mm
Please see detection zone
0 to 200 mm
1.300 mm 0 to 350 mm
3.400 mm
2.000 mm
Please see detection zone 5.000 mm
Please see detection zone
0 to 600 mm
6.000 mm
8.000 mm
Please see detection zone
Transducer frequency
Resolution, sampling rate
Reproducibility
Accuracy
320 kHz
0,18 mm 400 kHz
0,18 mm
± 0,15 %
Temperature drift internal compensated,
≤ 2 %
± 0,15 %
Temperature drift internal compensated,
≤ 2 %
Detection zones
for different objects:
The dark grey areas are determind
with a thin round bar (10 or 27 mm dia.)
and indicate the typical operating range
of a sensor. In order to obtain the light grey
areas, a plate (500 x 500 mm) is introduced
into the beam spread from the side.
In doing so, the optimum angle between
plate and sensor is always employed.
This therefore indicates the maximum
detection zone of the sensor.
It is not possible to evaluate ultrasonic
reflections outside this area.
Opperating voltage U B
Voltage ripple
may be deactivated 1) (0,17%/K without compensation) may be deactivated 1) (0,17%/K without compensation)
9 V to 30 V DC, short-circuit-proof
±10 % 9 V to 30 V DC, short-circuit-proof
±10 %
200 kHz
0,18 mm 120 kHz
0,18 mm
± 0,15 %
Temperature drift internal compensated,
≤ 2 %
± 0,15 %
Temperature drift internal compensated,
≤ 2 %
80 kHz
0,18 mm
± 0,15 %
Temperature drift internal compensated,
≤ 2 %
may be deactivated 1) (0,17%/K without compensation) may be deactivated 1) (0,17%/K without compensation)
9 V to 30 V DC, short-circuit-proof
±10 % 9 V to 30 V DC, short-circuit-proof
±10 %
may be deactivated 1) (0,17%/K without compensation)
9 V to 30 V DC, short-circuit-proof
±10 %
No-load supply current
Housing
≤ 80 mA
Brass sleeve, nickel-plated, plastic parts: PBT, TPU; ≤ 80 mA
Brass sleeve, nickel-plated, plastic parts: PBT, TPU;
Ultrasonic transducer: polyurethane foam,
epoxy resin with glass content Ultrasonic transducer: polyurethane foam,
epoxy resin with glass content
Class of protection to EN 60529
Norm conformity
Type of connection
Controls
IP 67
EN 60947-5-2 IP 67
EN 60947-5-2
5-pin initiator plug, PBT
2 push-buttons (TouchControl) 5-pin initiator plug, PBT
2 push-buttons (TouchControl)
≤ 80 mA
Brass sleeve, nickel-plated, plastic parts: PBT, TPU; ≤ 80 mA
Brass sleeve, nickel-plated, plastic parts: PBT, TPU;
Ultrasonic transducer: polyurethane foam,
epoxy resin with glass content Ultrasonic transducer: polyurethane foam,
epoxy resin with glass content
≤ 80 mA
Brass sleeve, nickel-plated, plastic parts: PBT, TPU;
Ultrasonic transducer: polyurethane foam,
epoxy resin with glass content
IP 67
EN 60947-5-2 IP 67
EN 60947-5-2
5-pin initiator plug, PBT
2 push-buttons (TouchControl) 5-pin initiator plug, PBT
2 push-buttons (TouchControl)
IP 67
EN 60947-5-2
5-pin initiator plug, PBT
2 push-buttons (TouchControl)
Indicators
Programmable
Operating temperature
Storage temperature
3-digit LED-display, 2 three-colour LEDs
Yes, with TouchControl and LinkControl 3-digit LED-display, 2 three-colour LEDs
Yes, with TouchControl and LinkControl
-25°C to +70°C
-40°C to +85°C -25°C to +70°C
-40°C to +85°C
Weight
Switching hysteresis 1)
switching frequency 1)
Response time 1)
150 g
3mm 150 g
5 mm
11 Hz
50 ms 8 Hz
70 ms
3-digit LED-display, 2 three-colour LEDs
Yes, with TouchControl and LinkControl 3-digit LED-display, 2 three-colour LEDs
Yes, with TouchControl and LinkControl
-25°C to +70°C
-40°C to +85°C -25°C to +70°C
-40°C to +85°C
3-digit LED-display, 2 three-colour LEDs
Yes, with TouchControl and LinkControl
-25°C to +70°C
-40°C to +85°C
150 g
20 mm 210 g
50 mm
6 Hz
110 ms 3 Hz
180 ms
270 g
100 mm
2 Hz
240 ms
Time delay before availibility
Order No.
Switched output
< 300 ms < 300 ms
mic+25/DDIU/TC
2 x pnp, U
B - 2 V, I max = 2 x 200 mA
mic+35/DDIU/TC
2 x pnp, U
B - 2 V, I max = 2 x 200 mA
Current output 4 – 20 mA
switchable NOC/NCC, short-circuit-proof
R
L
≤ 100 Ω at 9 V ≤ U
B
≤ 20 V;
switchable NOC/NCC, short-circuit-proof
R
L
≤ 100 Ω at 9 V ≤ U
B
≤ 20 V;
R L
≤ 500 Ω at U
B
≥ 20 V
Rising/falling output characteristic
R L
≤ 500 Ω at U
B
≥ 20 V
Rising/falling output characteristic
< 300 ms < 300 ms
mic+130/DDIU/TC
2 x pnp, U
B - 2 V, I max = 2 x 200 mA
mic+340/DDIU/TC
2 x pnp, U
B - 2 V, I max = 2 x 200 mA
< 300 ms
mic+600/DDIU/TC
2 x pnp, U
B - 2 V, I max = 2 x 200 mA
switchable NOC/NCC, short-circuit-proof
R
L
≤ 100 Ω at 9 V ≤ U
B
≤ 20 V;
switchable NOC/NCC, short-circuit-proof
R
L
≤ 100 Ω at 9 V ≤ U
B
≤ 20 V;
R L
≤ 500 Ω at U
B
≥ 20 V
Rising/falling output characteristic
R L
≤ 500 Ω at U
B
≥ 20 V
Rising/falling output characteristic
switchable NOC/NCC, short-circuit-proof
R
L
≤ 100 Ω at 9 V ≤ U
B
≤ 20 V;
R L
≤ 500 Ω at U
B
≥ 20 V
Rising/falling output characteristic
Voltage output 0 – 10 V
1) Can be programmed with TouchControl and LinkControl
R L
≥ 100 kΩ at U
B
≥ 15 V, short-circuit-proof
Rising/falling output characteristic
R L
≥ 100 kΩ at U
B
≥ 15 V, short-circuit-proof
Rising/falling output characteristic
R L
≥ 100 kΩ at U
B
≥ 15 V, short-circuit-proof
Rising/falling output characteristic
R L
≥ 100 kΩ at U
B
≥ 15 V, short-circuit-proof
Rising/falling output characteristic
R L
≥ 100 kΩ at U
B
≥ 15 V, short-circuit-proof
Rising/falling output characteristic
2 pnp switched outputs + analogue output
+U
B
-U
B
IU
D2
D1
1
2
4
5
3
U
mic+25… mic+35… mic+130… mic+340… mic+600…
0 cm
5 cm
10 cm
15 cm
20 cm
25 cm
30 cm
35 cm
ausgerichtete Platte
Rohr ø 10 mm
10 cm 5 cm 0 cm 5 cm 10 cm
Plate
Round bar
0 cm
10 cm
20 cm
30 cm
40 cm
50 cm
60 cm
ausgerichtete Platte
Rohr ø 27 mm
20 cm 10 cm 0 cm 10 cm 20 cm
35 cm
Plate
Round bar
0 m
0,4 m
0,8 m
1,2 m
1,6 m
2 m
1,3 m
ausgerichtete Platte
Rohr ø 27 mm
0,8 m 0,4 m 0 m 0,4 m 0,8 m
Plate
Round bar
0 m
0,8 m
1,6 m
2,4 m
3,2 m
4 m
4,8 m
5,6 m
3,4 m
ausgerichtete Platte
Rohr ø 27 mm
1,6 m 0,8 m 0 m 0,8 m 1,6 m
Plate
Round bar
0 m
1,2 m
2,4 m
3,6 m
4,8 m
6 m
7,2 m
8,4 m
ausgerichtete Platte
Rohr ø 27 mm
2,4 m 1,2 m 0 m 1,2 m 2,4 m
Plate
Round bar
The contents of this document are subject to technical changes. Specifications are presented in a descripted way only.
They do not warrant product features.
microsonic GmbH • Hauert 16 • D-44227 Dortmund • Tel: +49 (0)2 31 / 97 51 51-0 • Fax: +49 (0)2 31 / 97 51 51-51 •E-Mail: [email protected] • www.microsonic.de