Datel DKT2104-CT - Manual (Page 32)

The Handset
Using the Handset
20
Strata DKT2004-CT Cordless Digital Telephone 10/02
Using the Handset
➤ Pick up the handset and press 7$/. . You may see “ ACQUIRING LINK ” on the
LCD.
When the cordless digital telephone communicates between
the base unit and the handset, the screen goes to standby
(shown right), and the telephone is ready to use.
If you see “ NO SERVICE ” on the LCD when talking and the
handset is at the range limit of your cordless digital telephone, do the following:
➤ During a call, move back in range within 20 seconds.
➤ In standby mode, move back within range.
Note When the LCD shows “ DKT MODE ,” the telephone has not been transferred to
cordless mode at the base.
Charging the Handset
➤ Place the handset on the base unit either face down or face up (shown below), with
or without the belt clip attached.
The battery pack in the handset automatically recharges in either position.) For
information on charging the Battery Pack, see
page 14 .
1187
For Sales and Service call 508-580-2500
Tel: 508-580-2500 Datel Communications Fax: 508-583-8412