Nevion ETH1000-SFP - Manual (Page 6)

ETH1000-SFP Rev. A
nevion.com | 6
3
Configuration
Configuration of this card can either be done from Multicon Gyda element manager or locally
on the card by dipswitches.
3.1 DIP control
The tables below explain the functionality of the dip switches.
Figure 3
# Description
1. Enable 10Base-T
2. Enable 100Base-T
3. Enable 1000Base-T
4. Auto- negotiation on 1000Base-X
5. Reserved
6. Reserved
7. Reserved
8. GYDA override/DIP
When DIP switch 1, 2 and 3 are all on or off, speed is set to auto.
DIP switch 1 enables/disables 10Base-T electrical connection.
DIP switch 2 enables/disables 100Base-T electrical connection.
DIP switch 3 enables/disables 1000Base-T electrical connection.
DIP switch 4 enables/disables auto-negotiation on the optical connection, 1000Base-X.
When connecting ETH1000-SFP to ETH1000MC, auto-negotiation must be disabled. Using
two ETH1000-SFPs this DIPs must be in the same position on both cards. Also this dip must
be on to be able to communicate with other vendors Ethernet switches.
Dip 5, 6 and 7 are reserved.
Dip 8 sets if Multicon Gyda is able to configure or not. When Multicon Gyda override is set,
the actual setting can be read by using the info command (se Multicon Gyda user manual for
details).