Nevion DA-SDI - Manual (Page 8)

DA-SDI Rev. H
nevion.com | 8
4 Connector module
The DA-SDI has two dedicated connector modules: DA-SDI-C1 and DA-SDI-C2. These
modules are mounted at the rear of the sub-rack. The modules are shown in Figure 6
and Figure 7.
Figure 6: Overview of the DA-SDI-C1 connector module.
On DA-SDI-C1 the electrical input signal is connected to the IN BNC and the electrical
outputs are connected to the O1 to O6 BNC’s. Please note that all 6 outputs are non-
inverted and suitable for DVB-ASI.
Unused outputs should be terminated with 75 ohm.
DA-SDI-C1 also has GPI ALARM outputs on a RJ45 connector.