Denon DRA-397 - Manual (Page 23)

20
ENGLISH
Operating DENON audio components
Set [MODE SELECTOR 1] to “A” or “B”. 1
Operate the audio component.
For details, refer to the component’s operating instructions.
While this remote control is compatible with a wide range of
infrared controlled components, it may be the case that some
component models cannot be operated with this remote control.
3
Set [MODE SELECTOR 2] to the position for the
component to be operated.
2
Setting the preset memory function
Set [MODE SELECTOR 2] to the component to be
registered.
2
Set [MODE SELECTOR 1] to “A” or “B”.
Set to the A side for the CD/iPod, TV, DBS/CABLE or DVD
position, and to the B side for the CD-R/TAPE or VCR position.
1
• DENON and other makes of components can be operated by setting
the preset memory.
• This remote control unit can be used to operate components of
other manufacturers without using the learning function by
registering the manufacturer of the component as shown in the list
of preset codes (
End of this manual).
• Operation is not possible for some models.
Press [ZONE2 OFF] and [ZONE3 ON] at the same time.
• The indicator starts flashing.
3
Operating the remote control unit
ENGLISH
To store the codes of another component in the
memory, repeat steps 1 to 4. 5
• The signals for the pressed buttons are emitted while setting the
preset memory. To avoid accidental operation, cover the remote
control unit’s transmitting window while setting the preset memory.
• Depending on the model and year of manufacture, this function
cannot be used for some models, even if they are of makes listed in
the list of preset codes.
• Some manufacturers use more than one type of remote control
code. Refer to the included list of preset codes to change the
number and verify correct operation.
• The preset memory can be set for one component only among the
following: CD/iPod, DBS/CABLE and CD-R/TAPE.
Setting the punch through function
Set [MODE SELECTOR 1] to “A”. 1
Press [A] and [D] at the same time.
• The indicator starts flashing.
3
Set [MODE SELECTOR 2] to the component to be
registered (TV or DBS/CABLE).
2
“Punch Through” is a function allowing you to operate 1 , 2 , 0 , 3 ,
6 , 7 , 8 and 9 on CD, DVD/VDP, TAPE/CD-R/MD or VCR
components when in the TV or DBS/CABLE mode. By default, nothing
is set.
Input the number of the component you want to set. 4
No.
CD 1
DVD/VDP 2
TAPE/CD-R/MD 3
VCR 4
No setting 0
Operating a component stored in the preset
memory
Operate the component.
For details, refer to the component’s operating instructions.
Some models cannot be operated with this remote control unit.
Set [MODE SELECTOR 1] to “A” or “B”.
Set to the A side for the CD/iPod, TV, DBS/CABLE or DVD
position, and to the B side for the CD-R/TAPE or VCR position.
1
3
Set [MODE SELECTOR 2] to the component you want
to operate.
2
Referring to the included list of preset codes, press
[NUMBER] to input the preset code (a 3-digit number)
for the manufacturer of the component whose signals
you want to store in the memory.
4