Nortec MH Series - Manual (Page 38)

34 | MH Series
Mounting the MH Control Unit
Figure 26: Mounting the MH Control Unit
1. Fix the control panel to the wall using 4 x ¼” screws (not provided) within 30 ft (10 m) of the
hydraulic unit.
2. Select thread and length of fasteners based on mounting structure composition.
3. Connect the multi conductor control cables from the hydraulic unit to the corresponding terminals
in the control unit, according to the appropriate wiring diagram.
4. Important: all cables must be lead into the control unit via strain reliefs installed into the openings
in the bottom of the control panel housing.
5. MH Reflow models – Connect the power cable from the pump motor to the corresponding
terminals according to the appropriate wiring diagram.