Taking out of service / disposal – Nortec MH Series User Manual
Page 52
48 | MH Series
Notes on Fault Elimination
In order to eliminate faults, the NORTEC MH Series must be set out of operation as described in
this manual. Disconnect the unit from the mains and secure the unit against in advertent power-
up.
Only allow trained and qualified personnel to repair faults. Faults relating to electrical
installation must only be carried out by authorized personnel or your NORTEC representative’s
service technician.
Repair work and replacement of faulty components must only be carried out by your NORTEC
representative’s service technician.
Taking Out of Service / Disposal
Taking Out of Service
If the NORTEC MH must be replaced or if the humidification system is not needed any more,
proceed as follows:
1. Take the unit out of operation as described in this manual.
2. Have the unit (and all other system components, if necessary) un-mounted by a qualified
service
technician.
Disposal / Recycling
Dismantled components must be disposed of and/or recycled according to the local / national
regulations. In case of doubt, please contact your NORTEC supplier.