Preface, About this guide, Technician notes – OpenEye OE5 User Manual
Page 11
30720AB
11
PREFACE
ABOUT THIS GUIDE
This manual is a setup and maintenance guide that can be used for reference when setting up the X-Series HVR and
for troubleshooting when a problem occurs. Only authorized personnel should attempt to repair this unit.
OpenEye reserves the right to make changes to the products represented by this manual without notice.
The following text and symbols mark special messages throughout this guide:
Note
Text set off in this manner indicates information that is necessary for proper operation of the
product.
Tip
Text set off in this manner indicates information that may be helpful.
TECHNICIAN NOTES
Warning
Only authorized technicians trained by OpenEye should attempt to repair this HVR. All
troubleshooting and repair procedures that may be shown are for reference and minor
repair only. Because of the complexity of the individual components and subassemblies, no
one should attempt to make repairs at the component level or to make modifications to any
printed wiring board. Improper repairs can create a safety hazard. And any indications of
component replacement or printed wiring board modifications may void any warranty
Warning
To reduce the risk of electrical shock or damage to the equipment:
•
Do not disable the power grounding plug. The grounding plug is an important safety
feature.
•
Plug the power cord into a grounded (earthed) electrical outlet that is easily
accessible at all times.
•
Disconnect the power from the computer by unplugging the power cord either from
the electrical outlet or the computer.
Caution
To properly ventilate your system, you must provide at least 3 inches (7.6 cm) of clearance
at the front and back of the HVR.