OpenEye OE5 - Manual (Page 33)

30720AB 33
TURNING ON THE HVR
1. Turn on the monitor and any external peripherals(ex. Printers, External Storage Devices, etc.)
connected to the HVR.
2. Turn on the Secondary Power Switch located in the rear of the HVR.
3. Press the Power Switch located on the front of the HVR.
4. The HVR will run a series of self-tests. After two or three minutes, a series of messages may be
displayed as the various hardware and software subsystems are activated. Under normal
circumstances, users should not be asked to respond to these messages. If asked to respond to
the messages (adding a Printer, Monitor, etc for the first time) follow the instructions carefully.
5. Startup is complete when the OpenEye HVR software is finished loading and displays the main
menu screen.
TURNING OFF THE HVR
1. Click the Exit on the main menu screen of the HVR software.
2. Select Power Off from the drop down menu and click OK.
3. The HVR may take several minutes to shut down completely.
Caution Always be sure to follow the proper procedures when turning off the power to the HVR.
NEVER disconnect the power to the HVR while it is still running or in the process of
shutting down. Doing so can cause data loss, file corruption, system instability and
hardware failure.