OpenEye OE5 N-Series - Manual (Page 20)

20
N2 AND N4 RACKMOUNT KIT INSTALLATION
This section provides information on installing the OpenEye 2U and 4U NVRs into a rack unit with the
rack rails provided. There are a variety of rack units on the market which may mean the assembly
procedure will differ slightly. You should refer to the installation instructions that came with the rack unit
you are using.
Preparing for Setup
The box your OpenEye N2 NVR was shipped in should include two sets of rail assemblies, two rail
mounting brackets and the mounting screws you will need to install the system into the rack. Please
read this section in its entirety before you begin the installation procedure outlined in the sections that
follow.
Note
These rails are designed to fit a rack between 26 and 33.5 inches deep.
Separating the Section of the Rack Rails
The OpenEye N2 NVR package includes two rail assemblies in the rack mounting kit. Each assembly
consists of two sections: an inner fixed chassis rail that secures directly to the server chassis and an
outer fixed rack rail that secures directly to the rack itself.
1. Locate the rail assembly in the packaging.
2. Extend the rail assembly by pulling it outward.
3. Press the quick-release tab.
4. Separate the inner rail extension from the outer rail
assembly.
5. Repeat steps for the second rail assembly.