Quadral AURUM A5 - Manual (Page 7)

12
ENGLISH
13
• Never use the equipment in the vicinity of water, in humid areas or outdoors. Mois-
ture can bypass the electrical insulation and this will create a life-threatening risk
as is the case with all equipment that has not been specially designed against
the penetration of moisture.
• Protect the equipment against water being sprayed on it. You must also ensure
that no vessels containing liquid (e.g. vases) are placed on top of the equipment.
• Do not place the equipment in the vicinity of a heat source such as an electric
fire, radiator, oven or similar.
• The slits and openings in the enclosure provide the ventilation and ensure reliable
operation. They must never be misaligned or covered.
• Burning-out of specific components cannot be completely excluded, despite the
use of protective devices, if the equipment is severely overloaded by continually
using very loud sound levels. A fire might also be caused inside the equipment in
theory, as a result of this type of overloading. Therefore the amplifier should always
be used within its limits and it should not be left unattended.
• Only our technical service should undertake the maintenance of your equip-
ment. Maintenance will be necessary if any type of damage occurs, i.e. if the
power cables or plugs are damaged, if an object falls on the equipment, if the
equipment is dropped or if liquid seeps into it. Never open the equipment as you
might touch the mains voltage (230V / 115V), which is dangerous.
• Only use furniture and other units for attaching and putting the equipment on
that can be obtained from or are recommended by the manufacturer. You must
ensure that moveable tabletop units or shelves on which the equipment will be
placed are always moved very carefully in order to prevent damage or injuries
from being caused if the equipment tips over.
• Continuously loud volume can damage your hearing!
• Only use a dry, soft cloth to clean your equipment.
• Keep the packing for possible transportation use later on and keep the plastic
bag well away from children, due to the risk of asphyxiation.
Controls fitted on the front of the unit
1 On / Off switch: Press this button to switch the A5 / A3 on. Press this button once
again to switch the unit off (standby). All of the settings are saved in standby
mode.
2 Volume control: This rotary control is used to set the volume. The settings are dis-
played in 1 dB increments.
3 Input selector switch (source): Use this to select the source that you want to listen
to. Press the button continually to scroll through the available inputs. The current
settings are displayed on the screen.
4 Infrared receiver: This sensor receives the infrared signal transmitted by your
remote control. Always point the remote control in this direction and ensure that
the sensor is not covered up.
5 Display: Status information and messages that make using the amplifier easier are
displayed here.
6 Status display: This display is blue whenever the unit is in standby mode and this
indicates that the unit can be switched on at any time using either the remote
control or the button (1).
For operating display:
Flashing of this indicator shows that the protective circuits of the device have
disconnected the loudspeaker due to a fault or overloading. The device can
now only be put back into operation by using the power switch on its rear side.
A5
Volume Source
1
6
2
5
3
4
On | Standby