Operation – Desa LCR26PT User Manual

Page 15

Advertising
background image

www.desatech.com

15

121255-01A

Figure 21 - Burner Patterns

OPERATION

Continued

TO SELECT

HEATING LEvEL

WARNING: When running

heater, set control knob at LOW,

MED or HI locked positions.

Never set control knob between

locked positions. Poor combus-

tion and higher levels of carbon

monoxide may result.

CAUTION: Do not try to ad-

just heating levels by using the

equipment shutoff valve.

Turn thermostat control knob counterclock-
wise

to the desired heating level. The

main burner should light. Set control knob
to any heat level between 1 and 5 (see
Figure 21).

TO TURN OFF GAS

TO APPLIANCE

1. Turn control knob clockwise

to the

OFF position.

2. Turn off all electric power to the appliance

if service is to be performed.

3. Close equipment shutoff valve (see Figure

16, page 13).

THERMOSTAT CONTROL

OPERATION

The thermostatic control used on these
models differs from standard thermostats.
Standard thermostats simply turn on and off
the burner. The thermostat used on this heater
senses the room temperature. At times the
room may exceed the set temperature. If so,
the burner will shut off. The burner will cycle
back on when room temperature drops below
the set temperature. The control knob can
be set to any heat level between 1 and 5. All
plaques will turn off and on.
Note: The thermostat sensing bulb mea-
sures the temperature of air near the heater
cabinet. This may not always agree with
room temperature (depending on housing
construction, installation location, room size,
open air temperatures, etc.) Frequent use of
your heater will let you determine your own
comfort levels.

MANUAL LIGHTING

PROCEDURE

1. Remove front panel (see Figure 7, page 9).
2. Follow steps 1 through 7 under Lighting

Instructions, page 14.

3. With control knob pressed in, strike match.

Hold match to pilot until pilot lights.

4. Keep control knob pressed in for 30 sec-

onds after lighting pilot. After 30 seconds,
release control knob. Now follow step 9,
under Lighting Instructions, page 14.

5. Replace front panel.

Control Knob

Burners

Advertising
This manual is related to the following products: