Remko asf 100, Commissioning, Safety information – REMKO ASF 100 User Manual

Page 6

Advertising
background image

6

REMKO ASF 100

Prior to each commissioning
or as required, the air inlet and
outlet grilles must be checked for
clogging.

Important information
prior to commissioning

■

All electrical extension cables

must have a sufficient cross-
section and only be used fully
uncoiled.

■

Do not pull at the power cord.

■

After switching on, the units

operate fully automatically until
switched off controlled by the
timer or float switch of the full
condensate container.

■

The condensate container must

be fitted correctly.

The unit will not function if the
condensate container is not fit-
ted correctly!

■

For safety reasons, the units are

fitted with a tilt switch which
prevents operation of a unit
that has toppled over or is lying
vertically.

The unit can only be restarted
when it is placed upright!

■

In an unsupervised continuous

mode with external condensate
connection, the produced con-
densate is continuously drained
via a hose connection on the
condensate container.

Commissioning

Control panel

The control panel contains control
buttons and indicator lights.

➊

ON / OFF

The unit is switched on and off
with this button.
Note switch off delay of about
2 minutes.

➋

MODE

This button is used for selecting
the 3 modes “POWERFUL”,
“SILENT” and “NORMAL”.

➌

TIMER

This button is used to activate
the switch off timer for 2, 4 or 8
hours.

➍

AUTO SWING

This button is used to activate
the automatic swing mode of
the air directing flap.

➎

IONIC

This button is used to switch
on the ioniser for enriching
the room air with negatively
charged ions.

➏

”FULL TANK” indicator light
This indicator light shows when
the condensate container is full
and requires emptying. When
the unit is switched off via the
float switch, the unit generates
5 audible signals.

Safety information

The units were subjected to ex-
tensive material, functional and
quality inspections and tests prior
to delivery.

However, the units may constitute
a hazard if used by untrained per-
sonnel, improperly or not for the
intended purpose.

The following information must
be observed:

■

The units must not be installed
and operated in hazardous
areas.

■

The units must not be installed
and operated in oil, sulphur,
chlorine or salt containing
atmospheres.

■

The units must be installed up-
right and stable.

■

The units must not be exposed
to direct water jets.

■

The air openings must always be
kept free.

■

The air inlet grilles must always
be kept free of dirt and loose
objects.

■

The units must not be covered
during operation.

■

Never insert foreign objects into
the units.

■

The units must not be transport-
ed during operation.

■

The units must only be trans-
ported upright.

■

The condensate containers must
be emptied prior to each change
of location.

➊

➋

➌

➍

➎

➏

NOTE

Clogged grilles and filters must
immediately be cleaned or
replaced.

Advertising