REMKO ASF 100 - Manual (Page 9)

9
1. Remove the cover [F] from
the rear wall of the unit with a
suitable tool.
2. A suitable drainage hose of
sufficient length can be routed
to the outside through the free
opening.
The condensate must preferably
be discharged to a lower located
outlet in unsupervised continuous
duty.
When using an external container
(tub, bucket, etc.) the unit must be
placed in a raised position.
Decommissioning
ATTENTION
It must be ensured that the
drainage house is routed to the
drain with a gradient to ensure
that the condensate is able to
flow out freely!
Unit transport
F
Switch off the unit with
the ON/OFF button on
the control panel.
The mode LED extinguishes. The
unit initially switches off com-
pletely after lapse of a preset after-
running time of 2 minutes.
If the units are not
used for extended
periods of time,
they must be
disconnected from
the power supply.
The condensate container must be
emptied completely and dried with
a clean cloth.
Pay attention to subsequently
dripping condensate!
Prior to possible storage, the units
must be cleaned thoroughly and
dried.
For storage purposes, the units
should be covered with plastic
sheeting and stored in an upright
position in a protected and dry
location.
The units must only be stored
in upright in a suitable location
protected from dust and direct
sunlight.
ATTENTION
Never disconnect the unit
from the power supply during
operation by pulling out the
mains plug. This can damage
the control electronics.
Dam-
age of this kind is not covered
by the warranty
.
F
The units are provided with a
handle for easy and convenient
transport.
■ The unit must be switched off
and the plug removed from the
power socket each time before
the unit is moved to a different
location.
■ The condensate container must
be emptied completely.
■ As long as residual moisture is
still present in the unit or water
is present in the condensate
container, the units must only be
transported upright.
NOTE
Attention must be paid to
dripping condensate.
Condensate can still drip after
switching off the unit.
ATTENTION
The power cord must never
be used for pulling or fixing
purposes.