Remotec ZXT-120 V0.5 - Manual (Page 10)

10
are used
-
extend the battery life
by disabling the
Surround IR Emitters
33
(0x21)
AC function “SWING”
control 0x00: SWING OFF
0x01: SWING AUTO
(Default)
34
(0x22)
Indicate a location for
transmitting a learnt IR
code 1-20
(0x00 – 0x14)
Parameter Table
L Mapping Information
− BASIC Set Value 0x00 will map to Thermostat mode Off
0x00.
− BASIC set Value 0xFF will map to Thermostat mode Resume
0x05.
Listening Mode (default mode is FLiRS)
ZXT-120 can be configured as either “Frequently Listening Routing
Slaves” (FLiRS) or “Always Listening” node after exclusion process.
FLiRS node type is targeted for battery operated applications and it
will enter sleep mode frequently in order to conserve battery
consumption.
Always Listening node type is targeted for the needs of required a fast
response application.
Important:
It is not allow changing ZXT-120 operation mode without the step of
exclusion process.
How to switch ZXT-120 listening mode from “Always Listening＂ to
“FLiRS＂ (or vice verse)
Step Setup Key
LED Indication
Status on ZXT-120
1
Press and hold the PROG
button on the ZXT-120 for
around 4 seconds
• LED stay off
2
Release the button and
then press the PROG
• LED flashes twice
then stay off