Remotec ZXT-120 V0.5 - Manual (Page 13)

13
Reset ZXT-120 to factory default
Press and hold “PROG” button for 10seconds on ZXT-120. The LED
will flash twice until reset process is completed.
Note: This reset step will not affect the operation mode of ZXT-120,
user should refer to
“
Listening Mode
＂
section if you want to change
the operation mode.
L Important Information
− If you are using Gateway or other Z-wave controllers to
operate ZXT-120, Please follow the instruction from the
gateway or other controller.
− You can check either the specifications in the manual of your
ZXT-120 or also check online at www.remotec.com.hk for a
full list of products that can be used with your ZXT-120.