Remotec ZXT-120 V0.5 - Manual (Page 4)

4
ZXT-120 into their Z-Wave network using the primary controller.
Then, the user can use either the primary controller or secondary
controller to configure and setup the ZXT-120 using Z-Wave’s
configuration command class. Once the configuration and setup is
complete, the controller can use Z-Wave’s “Thermostat commands
class” to control their IR-controlled air-conditioner with the ZXT-120.
Controller and Gateway Requirements
The ZXT-120 is architected to work with any Z-Wave compliant
controller or gateway supporting the following Z-Wave commands.
-
Configuration Command Class
-
Multilevel Sensor Command Class
-
Sensor Configuration Command Class
-
Thermostat Command Class
ƒ
Thermostat Mode Command Class
ƒ
Thermostat Fan Mode Command Class
ƒ
Thermostat Set-point Command Class
Built-in IR code library
The built-in IR code library enables the ZXT-120 to work with any Z-
Wave compliant gateway and controller. Gateway and controller will
not need to have any knowledge related to IR control code. It also
eliminates the needs of complicated set up procedures and proprietary
Z-Wave commands to configure the system. The IR code library
supports various brand name air conditioners found in the today’s
market. User can use his controller or gateway to send a 3 digits AC IR
code number (include the brand selection) using standard Z-Wave
configuration command.